Water Treatment Station - POOL eTWIN PH / CL (SCLO3 HYCHLOR)
POOL eTWIN PH / CL (SCLO3 HYCHLOR) - automatic dosing and control system for PH and CL (free chlorine SCLO3 HYCHLOR) for swimming pools.
The dosing station is controlled by a liquid flow sensor (included), in the absence of flow the system goes into standby mode.
- Measurement and regulation of free chlorine - dosing of chlorine
- Measurement and regulation of pH value
- Measurement of water flow to shut off outputs when there is no flow
- Temperature sensor (PT100) allows you to automatically take into account temperature compensation - optional.
The station is equipped with two pumps (eTWIN PDP PH-CL) with integrated pH / CL controllers.
All main probes and sensors are installed in the SCLO 3 HYCHLOR flow cell. A connecting cable with an adapter is used to connect the chlorine sensor to the pump.
The dosing system POOL eTWIN PH / CL (SCLO3 HYCHLOR) is supplied mounted on a chemical-resistant plastic panel (450x600x8 mm), in a complete set, ready for installation and commissioning.
Specifications:
- The system is based on the eTWIN PDP PH-CL dosing pumps with integrated pH / Cl controllers and the SCLO 3 HYCHLOR free-flow flowmeter for chlorine.
- Dosing delay when the system is turned on.
- Level sensor or flow sensor alarm.
- Alarm settings for pH / Cl (MIN / MAX) concentration limits.
- Dosing modes: constant ON / OFF and proportional PROP.
- Set hysteresis.
- Pump productivity: 3 l / h - 1.5 bar.
- Measuring ranges: 0-14 pH 0-10 ppm (mg / l).
- Protection class (of pumps): IP65.
- Support for flow sensor and reagent level sensor.
Inputs / Exits :
- pH input.
- Cl input - 4-pin connector.
- 2 "LEV" inputs for SPDT level sensor pin 5 V / 5 mA.
- "FLOW input" "flow sensor (SPDT pin 5 V / 5 mA).
- 4-20 mA output.
- ON / OFF relay output for alarm.
Composition of the dosing system POOL eTWIN PH / CL [SCLO3 HYCHLOR]
1 pc. - eTWIN PDP 0301 230V PVDF pump
1 pc. - PH level sensor with 0.5 m cable.
1 pc. - chlorine sensor SCLO 3 HYCHLOR
1 pc. - cable with adapter for SCLO 3 HYCHLOR chlorine sensor
2 pcs. - reagent level sensor with 2 m cable.
1 pc. - mounting kit for SCLO 3 HYCHLOR chlorine sensor
1 pc. - calibration solution PH 7, 55ML
1 pc. - calibration solution PH 9, 55ML
2 pcs. - reagent injection valve
2 pcs. - reagent intake valve
2 pcs. - reagent intake hose, 4x6, PVC, 2 mp.
2 pcs. - reagent discharge hose, 4x6, PE, 2 m.p.
1 pc. - mounting plate 450x600x8 mm
Type | Performance, l / h |
Pressure, bar |
pH | CL | Price without VAT, (€) |
POOL eTWIN PH / CL (SCLO3 HYCHLOR) |
3 | 1.5 | 0 … 14 | 0-10 ppm | 1865 |